- Very good adhesion between different materials and supports
- Adhesion on humid materials
- High resistance to the atmospheric agents, acid rains, sea water
- High resistance to the solvents, basic environment (so, suitable for concrete) and acids
- Almost null shrinkage
How to use
PREPARATION OF THE SURFACES. Clean the surfaces carefully and remove any trace of dust, concrete, gypsum, greasy substances, etc. Better adhesion if the support is slightly roughened. PREPARATION OF THE TEXTURE. Mix carefully the component A and the component B in the exact ratio as indicated A:B=100:50. It is suggested the mixing of small quantity (max. 400-500 grams) to avoid a too much short time of use before the hardening reaction starts. APPLICATION. Apply the obtained texture on the clean and dry support by using a toothed putty knife. In case of application to the iron, it is advisable the iron is sandblasted or anyway roughened. After 8 to 10 hours it is possible to move the bonded piece and after 24 hours from the application the piece can be worked, grinded/polished